Ecolab EcoAdd

7.8.2.2 [Operating mode] [Pulse] - Quantity
Fig. 37: Operating mode: Pulse
1.
[Main menu] :
Ä Chapter 7.6 ‘Main menu’ on page 66
2. [Operating mode] - [Pulse]
- select.
3.
[Press the Next button] .
ð
Screen change for setting: ‘Pulse interval’.
4. DO NOT enter a pulse interval, or set pulse interval to 0!
T
o do this, set the decimal places to 0 using the scrollbar.
Then select the field for entering the decimal point and also set the decimal point to 0
using the scrollbar.
5.
[ Press the Next button] .
ð
The screen changes to the ‘Pulse memory’ prompt.
6. Select whether the ‘pulse memory’
is to be used.
ð
If you select the ‘Pulse memory’, a
appears in the selection box.
7.
Press the button.
ð
Settings are saved, and the screen returns to the [Operating mode] .
8.
Press the button.
ð
The screen switches back to the overview [Main menu] .
9.
Press the button.
ð
The screen switches back to the [Operating display] .
10. Keep the displayed value (l/pulse) for the rate pressed down for approx. 3 seconds.
ð
The configuration page for converting the unit (l/pulse) is displayed.
11. T
ap the required unit (l/pulse, ml/pulse, G/pulse) of the concentration setting and
select the required unit.
12.
Press the button.
ð
The screen switches back to the concentration setting.
13. If necessary
, adjust the concentration value with the newly set unit.
14.
Press the button.
ð
The screen switches back to the [Operating display] .
Control / software
76Rev. 2-05.2018