Ecolab EcoAdd

Fig. 31: Overview: metering mode
Factory setting: Standard
Selection of the metering mode:
1.
[Open main menu] by pressing the [Menu button] :
Ä Chapter 7.6 ‘Main menu’ on page 66.
2.
[Configuration menu] :
Ä Chapter 7.9 ‘Overview - Configuration’ on page 83
3. [Metering mode] - select.
ð
Screen switches to the [Metering mode].
4. Select the [Metering mode] :
The following settings can be selected:
n S-standard
n M-medium
n L-low
n V
-variable Ä Chapter 7.7.1 ‘[Metering mode] [Select V-variable]’ on page 71
5.
Press the button to save your settings.
ð
The screen changes to: [Main menu].
6.
Press the button.
ð
The screen switches back to the [Operating display] .
Control / software
70Rev. 2-05.2018