6.1.11. OVS Operator Virtual Shield [option]
OPS is a system that protects the operator from the
movements of the boom system when operating the crane.
It is integrated in the control system, and it uses a sensor
on the slewing system and boom angle sensors to detect
the position of the crane.
It creates a protected area where the boom system cannot
operate.
This feature is active only if an Effer authorised workshop
enables it.
6.1.12. Integration of a removable ballast and/or counterweight
The Progress system allows the use of a ballast (see figure A) and, with SENSE [option], also of a
removable counterweight (see figure B).
To tell Progress that you are using a ballast/counterweight,
activate the detection with the related selector. When the
system recognises correctly the ballast/counterweight, you
will hear a double beep sound.
When the system recognises the presence of these
accessories, it automatically increases the performance based on values defined and calculated
by the installer.
WARNING
• The ballast/counterweight must be of the type and in the position established
and calculated by the installer.
• There is danger of overturning and risk of serious accidents if the ballast/
counterweight or the location are different from the instructions from the installer.
NOTE
The assembly of the kit and the setup of this feature are the sole responsibility of
the installer.
6.1.13. FPI Flow Power Increase
This feature automatically provides extra power by reducing the speed smoothly when working
close to the rated capacity. When the load decreases, normal speed is restored.
During operation
104 EFFER 265-315-395-525 Progress 2.0 CE
To Next Page
Loading...