Effer 265 - Pump Flow Sharing; Automatic Oil Temperature Detection; Radio Hook [Option]; VS Virtual Shield [Option]

6.1.7. Pump flow sharing
When operating several functions simultaneously, the pump flow may not be sufficient. The pump
flow sharing system, controlled by Progress, will take over, reducing the speed of all operated
functions. Uncontrolled movements are thus avoided, and smooth simultaneous operation is
achieved. Progress adjust the quantity of the oil that needs to be reserved for each single function.
6.1.8. Automatic oil temperature detection
The Progress system detects the oil temperature with a sensor on the oil cooler.
• When the oil reaches 40ºC, the oil cooler starts running at the minimum speed that gradually
increases up to the maximum speed when the oil reaches 60˚C.
• When the oil reaches 70ºC, the system generates a warning 'WN 017 Wrn – OilTempHigt'.
• When the oil reaches 80ºC, the system gives a visual warning 'WN 027 Wrn – OilTempTooHi'
and a sound warning, but it does not stop the crane.
NOTE
Green light on the display panel blinks when
the oil cooler is activated.
6.1.9. Radio hook [option]
A device on the hook detects the weight of the load attached to the hook and shows the value
in Kg on its display and the controller display. On the controller display, the value is shown as an
alternative to the value detected on the hoist if the hoist is not in use.
NOTE
The safety calculations of Progress for the moment limiter do not include this
value. Also, the value detected cannot be used for commercial purposes.
To recharge the device that transmits the detected weight, connect it to the cigarette lighter socket
in the truck cabin.
6.1.10. VS Virtual Shield [option]
This feature protects the truck cabin from the movements
of the boom system when operating the crane.
It is integrated in the control system, and it uses a sensor
on the slewing system and boom angle sensors to detect
the position of the crane.
It creates a virtual cage around the area where the truck
cabin stands.
This feature is active only if an Effer authorised workshop
enables it.
During operation
EFFER 265-315-395-525 Progress 2.0 CE 103