Effer 265 - Emergency Operation; Display Messages and Password

7.4. Emergency operation
7.4.1. Display messages and password
WARNING
• The use of any emergency operation is under your direct responsibility as
operator of the crane.
• You must be qualified and correctly trained in the emergency operation to use
the manual commands unit. Pay careful attention when operating from the
operator station (crushing, falling, etc...) and watch out for hidden hazards (low
visibility, narrow spaces, etc...).
• Always operate the crane with caution and at reduced speed.
• To operate the crane like this is HIGHLY DANGEROUS because during
emergency operation all crane security is disconnected.
• It is strictly forbidden to use any emergency operation as normal operation (for
example lifting a load).
• Always go to/contact an authorised service workshop when a security seal has
been broken.
The controller and the display panel [option] show information about the cause of all malfunctions
with a code and a description. Contact an authorised service workshop to understand the errors.
The messages can be about:
• Warning: the crane remains operative and the messages inform the driver about specific
operating conditions.
• Alarm: the crane is no longer operative. It is possible to reset several alarms and continue
operating the crane, but there are also alarms that require the support of technical service.
NOTE
When you enter the password to disable all the control and safety systems on the
crane, Progress saves the date and the time in which you use the crane with the
safety systems disabled.
Contact an authorised service workshop to get the password and the procedure.
NOTE
If your password does not allow movements of the crane or the stabiliser system to
fold the crane in transport position, you must operate the crane manually.
Ending crane operation
EFFER 265-315-395-525 Progress 2.0 CE 131