Effer 265 - 8 Maintenance and Service; Service

8. Maintenance and Service
8.1. Service
No welding/drilling work on the crane
DANGER
• Do not do any welding work on the crane.
Welding work on the crane may only
be carried out by an authorised service
workshop.
• Do not drill into the crane yourself. Drilling
work on the crane may only be carried out
by an authorised service workshop.
• Never try to reinstall the crane. Only
an authorised Installer may reinstall the
crane.
Disconnecting hydraulic lines for accessories
You can disconnect a hydraulic line or a hose only for specific operator’s tasks (for example,
disconnecting the JIB or other accessories).
1. Make sure that the cylinders are not at the end of stroke and minimise as much as possible the
forces acting on them.
2. Switch off the system.
3. Disengage the PTO.
4. Make sure that you wear the correct personal protective equipment.
5. Slowly loosen all connectors.
Leakages
DANGER
• STAY AWAY from oil leaks in the hydraulic system! Oil in the hydraulic system is
under high pressure, can spill, be very hot and cause you injury.
• Do not replace any hydraulic hoses or lines yourself.
Deal with an oil leak as follows:
1. Rest the crane on the floor or on the truck platform.
2. Switch off the control system.
3. Disengage the PTO.
Maintenance and Service
EFFER 265-315-395-525 Progress 2.0 CE 141