4.11. STEADY controller
STEADY controller system consists of:
• a controller unit with buttons/selectors and levers
• a receiver
• an emergency cable
• two batteries
• a battery charger and its accessories
• a belt/shoulder strap
The controller normally communicates with the crane
through the receiver via radio, but it can also be used with
a cable (when the batteries are discharged or when the use
of radio frequencies is forbidden).
CAUTION
• Use the support strap for safe operation.
• Never leave the remote unattended.
• Disconnect it and store it in a safe place when not in use.
NOTE
• For safety reasons, and to minimise battery consumption, the controller
automatically turns off after 5 minutes of inactivity.
• To have a correct communication between the controller and the crane system,
the controller cannot be more than 100 meters away from the crane without
large obstacles in between.
4.11.1. Buttons, selectors, and LEDs
The control system
56 EFFER 265-315-395-525 Progress 2.0 CE
To Next Page
Loading...
