Hydraulically-controlled tiltable stabiliser legs (180º)
DANGER
Stay away from the tilting area of the stabiliser leg.
When the leg turns, there is a risk of injury.
Always keep your hands away from the moving parts during this operation.
Make sure the tilting mechanism remains unlocked during the complete
tilting.
1. Turn lever (A) to the horizontal position.
2. Retract the stabiliser leg completely.
3. Remove the extra support plate.
4. Turn lever (A) to the vertical position.
5. Remove the cotter pin and the pin (B).
6. Operate the rotation stabiliser leg lever. The
stabiliser leg will now rotate automatically to
vertical position.
7. Insert the pin and cotter pin (B) to lock the
stabiliser leg.
8. Retract the stabiliser extension completely. Make
sure that it is security locked. (Refer to the
section: "Retract the stabiliser extensions").
WARNING
• Always do a check that the stabiliser
legs and the stabiliser extensions are in
the correct position and that the tilting
mechanism is locked in transport position.
• Remember that the valve lever of the
stabiliser leg has two positions:
◦ In the horizontal position (A), it activates
the stabiliser leg up/down movements.
◦ In the vertical position (B) ,it activates
the stabiliser leg tilting movement.
Ending crane operation
128 EFFER 265-315-395-525 Progress 2.0 CE
To Next Page
Loading...
