NOTE
The lateral deflection sensor (if installed) blocks
the crane movements causing side swaying
on the last boom extension, and the warning
message 'B4 010' appears on the controller
display. To solve it, operate the crane to the
transport position and level the vehicle completely.
If the error does not disappear, go to an
authorised service workshop.
NOTE
When working in vertical position, the load swinging can generate a not-real
overload detection. In these cases, push the reset button to continue with crane
operations.
• When heavy loads are applied to the crane to avoid over-pressures.
• With flow sharing to allow simultaneous crane movements.
• When there is a need to limit the maximum crane hook speed to prevent damage to the
crane or the load.
• When working with the “MAX boom elevation” to
avoid overturning the vehicle. The 2nd boom can go
against the 1st boom, when the 2nd boom goes over
a 30º angle, you will have different warnings on the
crane.
WARNING
When the conditions that activate the automatic slow-down are no longer detected,
the crane speed automatically increases.
NOTE
When the maximum speed is reduced by
Progress for safety reasons (despite any
activated feature), the green light blinks.
During operation
EFFER 265-315-395-525 Progress 2.0 CE 99
To Next Page
Loading...
