Eldes ESIM384 - Bell Squawk in Stay Mode

102
102
EN
ESIM384 Installation and Conguration Manual v1.1
EKB3/
EKB3W/
EWKB4
Enter parameter 29 and parameter status value:
29 1 #
Example: 291#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
Disable Bell Squawk
EKB2
Menu path:
OK → iiii → OK → PRIMARY SETT INGS → OK → SIREN SETTINGS → OK → BELL SQUAWK → OK
→ DISABLE → OK
Value: iiii – 4-digit installer code.
EKB3/
EKB3W/
EWKB4
Enter parameter 29 and parameter statusvalue:
29 0 #
Example: 290#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
20.3. Bell Squawk in Stay Mode
If enabled, the Bell Squawk will be available when arming/disarming the system in Stay mode (see 15. STAY MODE). To enable/disable this
feature, please refer to the following conguration methods
Enable Bell Squawk
in Stay Mode
EKB2
Menu path:
OK → iiii → OK → PRIMARY SETT INGS → OK → SIREN SETTINGS → OK → BELL SQUAWK STAY
→ OK → ENABLE → OK
Value: iiii – 4-digit installer code.
EKB3/
EKB3W/
EWKB4
Enter parameter 95 and parameter status value:
95 1 #
Value: 951#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
Disable Bell Squawk
in Stay Mode
EKB2
Menu path:
OK → iiii → OK → PRIMARY SETT INGS → OK → SIREN SETTINGS → OK → BELL SQUAWK STAY
→ OK → DISABLE → OK
Value: iiii – 4-digit installer code.
EKB3/
EKB3W/
EWKB4
Enter parameter 95 and parameter status value:
95 0 #
Value: 950#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.