Eldes ESIM384 - User Phone Number Names; System Control from any Phone Number

35
35
EN
ESIM384 Installation and Conguration Manual v1.1
Delete user phone
number
SMS
SMS text message content:
ssss_NRup:DEL
Value: ssss – 4-digit SMS password; up – user phone number slot, range – [2... 10].
Example: 1111_NR2:DEL
EKB2
Menu path:
OK → iiii → OK → PRIMARY SETTINGS → OK → CALL/SMS SETTINGS → OK → USERS → OK →
GSM USER 2... 10 → OK → PHONE NUMBER → OK → OK
Value: iiii – 4-digit installer code;
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
ATTENTION: NEVER add a phone number of the device’s SIM card as a user phone number!
ATTENTION: Once User 1 phone number is set, it will be restricted to modify it only.
NOTE: Multiple user phone numbers can be set by a single SMS text message,
Example: 1111_NR1:+44170911XXXX1_ NR2:+44170911XXXX2_NR6:0170911XXXX3_NR10:+44170911XXXX4
NOTE: Multiple user phone numbers can be deleted by a single SMS text message, Example: 1111_NR2:DEL_NR3:DEL_NR6:DEL_NR9:DEL_
NR:10:DEL
8.1. User Phone Number Names
When the system is armed or disarmed by free of charge phone call or SMS text message, the system sends a conrmation by SMS text mes-
sage to user phone number that the system arming/disarming was initiated from. The SMS text message is sent regarding each partition
separately and contains system status and partition name as well as it may contain a user name, set to the user phone number.
Manage user phone
number name
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
8.2. System Control from any Phone Number
By default, once a user phone number is listed, the system ignores any incoming calls and SMS text messages from a non-listed phone
number as well as it rejects the SMS text messages containing wrong SMS password even from a listed user phone number. To permit/deny
system arming/disarming by phone call and SMS text message that contain a valid SMS password, conguration by SMS text message that
contain a valid SMS password from any phone number, please refer to the following conguration methods.
Enable system control
from any phone
number
SMS
SMS text message content:
ssss_STR:ON
Value: ssss – 4-digit SMS password.
Example: 1111_STR:ON
EKB2
Menu path:
OK → iiii → OK → PRIMARY SETTINGS → OK → CALL/SMS SETTINGS → OK → CTRL FROM ANY
NUM → OK → ENABLE → OK
Value: iiii – 4-digit installer code;
EKB3/
EKB3W/
EWKB4
Enter parameter 12 and parameter status value:
12 1 #
Example: 121#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
ATTENTION: Due to security reasons it is HIGHLY UNRECOMMENDED to enable this feature.