Eldes ESIM384 - Tamper Names

To Next Page

To Previous Page

ESIM384 Installation and Conguration Manual v1.1

EKB3/

EKB3W/

EWKB4

Enter parameter 25/21/55, event number, user phone number slot and parameter

status value:

User phone number: 25 13 up 1 #

SMS text message to all users simultaneously: 21 13 1 #

SMS delivery report: 55 13 1 #

Value: up - user phone number slot, range - [01... 10].

Example: 2513041#

ELDES

Cong-

uration

soft-

ware

This operation may be carried out from the PC using the ELDES Conguration software.

For more details on how to view violated tamper, please refer to 17. ALARM INDICATIONS AND NOTIFICATIONS FOR USER.

ATTENTION: Once a certain tamper is disabled, the system will NOT deliver any text message regarding the physical tamper violation nor

wireless signal loss or restore.

ATTENTION: The system will NOT deliver any text message regarding wireless signal loss or restore while the physical tamper violation is

in progress.

ATTENTION: The system will NOT cause any tamper alarm regarding the physical tamper violation nor wireless signal loss if the associated

zone is disabled (excepting EWKB 4 on board zone).

16.1. Tamper Names

Each tamper has a name that can be customized by the user. The tamper names are used in SMS text messages that are sent to the user

during the tamper alarm. By default, the tamper names are: Tamper 1, Tamper 2, Tamper 3, Tamper 4 etc. To set a dierent tamper name,

please refer to the following conguration methods.