Eldes ESIM384 - 10 Master and User Codes

38
38
EN
ESIM384 Installation and Conguration Manual v1.1
10. MASTER AND USER CODES
NOTE for EKB3/EKB3W/EWKB4: The Conguration mode must remain deactivated before accessing master and user code manage-
ment using the master code.
The system supports up to 30 numeric codes, identied as Master code and User code 2 through 30, allowing to carry out system arming/
disarming as well as minor system conguration and control by the keypad.
Master code is authorized to carry out the following:
• Arm/disarm partition.
• Bypass violated zones.
• View violated zones and tampers.
• View system faults.
• Set system date and time.
• View temperature sensor information.
• View event log,
• View and clear alarm log,
• Set/delete user codes.
• Turn ON/OFF PGM outputs.
• Assign an existing user code as Duress code.
• Assign an existing user code as SGS code.
User code is authorized to carry out the following:
• Arm/disarm partition.
• Bypass violated zones.
• View violated zones and tampers.
• View system faults.
• Set system date and time.
• View temperature sensor information.
• View and clear alarm log.
By default, only Master code is listed as 1111 and assigned Partition 1 ONLY. For more details regarding User/Master code partition, please
refer to 23.4. User/Master Code Partition.
Set master code
EKB2
Menu path:
a) OK → vvvv → OK → CODES→ OK → MASTER CODE → OK → CODE → OK → mmmm → OK
b) OK → iiii → OK → PRIMARY SETTINGS → OK → MASTER CODE → mmmm → OK
Value: vvvv – 4-digit existing master code, range – [0000... 9999]; iiii – 4-digit installer code;
mmmm – 4-digit new master code, range – [0000... 9999].
EKB3/
EKB3W/
EWKB4
a) Press , 0, enter existing master code and new master code:
0 vvvv 01 mmmm # mm #
Value: vvvv – 4-digit existing master code; mmmm - 4-digit new master code; range -
[0000... 9999].
Example:
01111012222#
b) (Only when Conguration Mode is activated);
Enter parameter 63, existing master code and new master code:
63 vvvv mmmm #
Value: vvvv – 4-digit existing master code; mmmm – 4-digit new master code, range –
[0000... 9999].
Example: 6311112222#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.