Eldes ESIM384 - Audio Files and Introduction Audio

72
72
EN
ESIM384 Installation and Conguration Manual v1.1
EKB3/
EKB3W/
EWKB4
Enter parameter 25/21/55, event number, user phone number slot and parameter
status value:
User phone number: 25 03 up 1 #
SMS text message to all users simultaneously: 21 03 1 #
SMS delivery report: 55 03 1 #
Value: up - user phone number slot, range - [01... 10].
Example: 2503101#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
By, default the system will not ring the listed phone number via PSTN in case of alarm. To manage this feature, please refer to 30.2.3.
PSTN)
For more details on how Send SMS text message to all users simultaneously and SMS Cascade parameters aect the SMS text message
transmission, please refer to 27. SYSTEM NOTIFICATIONS.
By default, tamper alarm notication by SMS text message is enabled. For more details on how to disable/enable tamper alarm notication,
please refer to 16. TAMPERS.
ATTENTION: Regardless of the Call in Case of Alarm parameter status, the system will NOT ring the listed user phone number via GSM net-
work if the system is connected to the monitoring station (see 30. MONITORING STATION).
17.2. Audio Files and Introduction Audio
The system comes equipped with a feature, allowing to record up to 16 audio les of up to 6 seconds length, and another feature, which
allows to record 1 introduction audio le of up to 20 seconds length,using the microphone of the PC. Recorded les can be assigned to any
system zone and be played when the alarm is caused by zone with an audio le assigned, These features will be available only if the system
is able to dial user phone number in the event of an alarm and the user answers the call. When the call is answered, the primarily recorded
introduction audio le (if assigned), containing essential information (location/ full address or/and user full name) is being played, while
the audio le (up to 6 sec. long) will come up just after introduction audio has ended. The supported audio le format is as follows:
• Max. number of audio les: up to 16
• Max. audio length: up to 6 seconds
• Max. number of introduction audio les: 1
• Max. introduction audio length: up to 20 seconds
• File format: .wav
• Specications: 8,000 kHz; 8 Bit; Mono
By default, none of these audio les are pre-recorded or assigned to any particular zone. To record an introduction audio or audio le and/
or assign it to a zone, please refer to the following conguration method.
Record and manage
audio les
ELDES
Cong-
uration
soft-
ware
This operation may be carried out from the PC using the ELDES Conguration software.
Assign audio le to
individual zone
ELDES
Cong-
uration
soft-
ware
This operation may be carried out from the PC using the ELDES Conguration software.
NOTE: Single audio le can be assigned to multiple zones.