ELITE OPERATOR’S MANUAL
186
ADF RECEIVER
ADF KR 27 TSO
ADF Pressed: ADF Mode
ADF Depressed: Antenna Mode
Press Here for BFO Mode
Flip / Flop
Power On: Drag
Right to Receive
Identifi er
Change Frequency
Press SET to Reset ET,
Press SET for 2 Sec for
Selectable Timer Mode
Set Timer for Flight Time (FT)
The Automatic Direction Finder Receiver (ADF) in ELITE
selects a Non Directional Beacon ( NDB) in the frequency
range ±600 Hz around the frequency set. This means that,
for example, an NDB with a frequency of 371.5 kHz may
be received with the ADF set to either 371 or 372.
NOTE: When a receiver is tuned to a frequency, the closest
NAVaid with this frequency is received. When two facilities
in the same area have identical frequencies, ELITE will
show a dialog box to select the desired one.
MARKER RECEIVER
The Marker Receiver can be switched
to LO, HI and TEST. The LO selection
may be made to set marker reception
to low sensitivity, i.e. markers will only
receive data at a short distance, such as
during the approach. The marker lamp
panel consists of the conventional: A lamp (white when lit,
airway marker, inner marker), O lamp (blue when lit, outer
marker), M lamp (amber when lit, middle marker).
When passing a marker, the appropriate identifi cation code
is heard while the corresponding marker lamp fl ashes. The
duration of the marker reception as well as the reception
range depends on the type of marker.
To Next Page
