Emerson Rosemount 2460 System Hub - Sending a Servo Command

175
Servo Commands
Servo Commands
October 2018
Reference Manual
00809-0100-2460, Rev DE
Appendix D Servo Commands
Sending a servo command . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 175
Servo states . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 179
Type of request (TOR) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 180
For tanks configured as servo tanks, it is possible to send commands to a servo gauge, such as an Enraf
®
series 854, using the Servo Command window.
D.1 Sending a servo command
To send a servo command, a tank must first be configured as a servo tank. See the Rosemount Tank
Gauging System Configuration Manual (Document No. 00809-0300-5100) manual for more information
on tank installation and configuration.
To send a servo command:
1. Right-click on a servo tank in the Workspace window and select Send Servo Command in the menu
to open the Servo Command window, or select Entry > Send Servo Command in the main toolbar.