Emerson Rosemount 2460 System Hub - To Stop Logging

120
Reference Manual
00809-0100-2460, Rev DE
Service and Troubleshooting
October 2018
Service and Troubleshooting
6.9.1 To stop logging
To stop communication logging:
1. Make sure that all ports are disabled, i.e. all check boxes are unchecked. Also make sure that Modbus
TCP logging is set to None:
2. Click the Apply button.
Note
Modbus TCP does only appear in case the current license includes Modbus TCP Host Communication.
See “Ordering information” on page 163.
Note
Logging will stop temporarily in case a USB stick or SD card is umounted, Logging will be resumed when
the USB stick /SD card is replaced again.