76
Reference Manual
00809-0100-2460, Rev DE
Configuration
October 2018
Configuration
4.3.7 Redundancy configuration
Setting up a redundant pair of Rosemount 2460 system hubs can be done by using TankMaster WinSetup
or the Web Graphical Interface. This section describes the redundancy setup in the WinSetup
configuration wizard for the Rosemount 2460 System Hub. See “Redundancy setup via Web GUI” on
page 80 for a description of how to use the Web interface for redundancy configuration.
The installation wizard for the Rosemount 2460 includes the option to setup a redundant pair of
Rosemount 2460 System Hubs as long as certain conditions are fulfilled. See “Preconditions for
redundancy setup” on page 53 for more information.
Redundancy configuration is part of the TankMaster WinSetup installation wizard for the Rosemount
2460 System Hub. In case all requirements for pairing are fulfilled (see “Preconditions for redundancy
setup” on page 53), the following text appears: “Pairing is possible, Backup device ID:xx”.
Click the Create New Pair button to start the redundancy synchronization procedure. When finished, a
message appears that the database synchronization was successfully completed. The system hubs will
be paired as a Primary and a Backup device.
To Next Page
Loading...
