Endress+Hauser HART Proline t-mass I 300 - Page 101

Proline t-mass I 300 HART Commissioning
Endress+Hauser 101
Parameter Prerequisite Description Selection / User
entry
Factory setting
0% bargraph value 1 A local display is provided. Enter 0% value for bar graph
display.
Signed floating-point
number
–
100% bargraph value 1 A local display is provided. Enter 100% value for bar
graph display.
Signed floating-point
number
Depends on country
and nominal
diameter
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
the Value 1 display
parameter
(→  100)
–
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
the Value 1 display
parameter
(→  100)
–
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
–
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
–
Value 4 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
the Value 1 display
parameter
(→  100)
–
* Visibility depends on order options or device settings