Endress+Hauser Levelflex FMP55 - Medium Group; Tank Type; Tube Diameter

Levelflex FMP55 HART Operating menu
Endress+Hauser 129
Selection SI units
• mm
• m
US units
• ft
• in
Factory setting m
Tank type 
Navigation  Setup → Tank type
Prerequisite Medium type = Liquid
Description Select tank type.
Selection • Metallic
• Bypass / pipe
• Non metallic
• Mounted outside
• Coaxial
Factory setting Depending on the probe
Additional information • Depending on the probe some of the options mentioned above may not be available or
there may be additional options.
• For coax probes and probes with metallic center washer Tank type parameter
corresponds to the type of probe and cannot be changed.
Tube diameter 
Navigation  Setup → Tube diameter
Prerequisite • Tank type (→  129) = Bypass / pipe
• The probe is coated.
Description Specify diameter of bypass or stilling well.
User entry 0 to 9.999 m
Factory setting 0.0384 m
Medium group 
Navigation  Setup → Medium group
Prerequisite • For FMP51/FMP52/FMP54/FMP55: Operating mode (→  128) = Level
• Medium type = Liquid