Endress+Hauser Levelflex FMP55 - Use Calculated DC Value

Operating menu Levelflex FMP55 HART
146 Endress+Hauser
Use calculated DC value 
Navigation  Setup → Advanced setup → Interface → Use calculated DC value
Description Specify whether the calculated dielectric constant is to be used.
Selection • Save and exit
• Cancel and exit
Factory setting Cancel and exit
Additional information Meaning of the options
• Save and exit
The calculated constant is assumed to be the correct one.
• Cancel and exit
The calculated dielectric constant is rejected; the previous dielectric constant remains
active.
On the local display, the Calculated DC value parameter (→  145) is displayed
together with this parameter.