Endress+Hauser Levelflex FMP55 - Page 147

Levelflex FMP55 HART Operating menu
Endress+Hauser 147
"Automatic DC calculation" wizard
The Automatic DC calculation wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the
automatic DC calculation are located directly in the Interface submenu (→  141)
In the Automatic DC calculation wizard two parameters are displayed simultaneously
on the display module at any one time. The upper parameter can be edited, whereas
the lower parameter is displayed for reference purposes only.
Navigation  Setup → Advanced setup → Interface → Automatic DC
calculation
Manual thickness upper layer 
Navigation  Setup → Advanced setup → Interface → Automatic DC calculation → Manual
thickness upper layer
Description →  144
DC value 
Navigation  Setup → Advanced setup → Interface → Automatic DC calculation → DC value
Description →  145
Use calculated DC value 
Navigation  Setup → Advanced setup → Interface → Automatic DC calculation → Use calculated
DC value
Description →  146