Operating menu Levelflex FMP55 HART
202 Endress+Hauser
17.5.6 "Simulation" submenu
The Simulation submenu is used to simulate specific measuring values or other
conditions. This helps to check the correct configuration of the device and connected
control units.
Conditions which can be simulated
Condition to be simulated Associated parameters
Specific value of a process variable • Assign measurement variable (→ 204)
• Process variable value (→ 204)
Specific value of the output current • Current output simulation (→ 204)
• Value current output (→ 205)
Specific state of the switch output • Switch output simulation (→ 205)
• Switch status (→ 205)
Existence of an alarm Device alarm simulation (→ 206)
Existence of a specific diagnostic message Diagnostic event simulation (→ 206)
To Next Page
Loading...
