Endress+Hauser Levelflex FMP55 - Value 1 to 4 Display

Levelflex FMP55 HART Operating menu
Endress+Hauser 179
Value 1 to 4 display 
Navigation  Setup → Advanced setup → Display → Value 1 display
Description Select the measured value that is shown on the local display.
Selection • Level linearized
• Distance
• Interface linearized
*
• Interface distance
*
• Thickness upper layer
*
• Current output 1
• Measured current
• Current output 2
*
• Terminal voltage
• Electronic temperature
• Measured capacitance
*
• Analog output adv. diagnostics 1
• Analog output adv. diagnostics 2
Factory setting For interface measurements and one current output
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Thickness upper layer
• Value 4 display: Current output 1
For interface measurements and two current outputs
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Current output 1
• Value 4 display: Current output 2
Decimal places 1 to 4 
Navigation  Setup → Advanced setup → Display → Decimal places 1
Description This selection does not affect the measurement and calculation accuracy of the device.
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xx
Additional information The setting does not affect the measuring or computational accuracy of the device.
* Visibility depends on order options or device settings