Endress+Hauser Levelflex FMP55 - Free Text; Level Linearized

Levelflex FMP55 HART Operating menu
Endress+Hauser 153
Selection SI units
• STon
• t
• kg
• cm³
• dm³
• m³
• hl
• l
• %
• mm
• m
US units
• lb
• UsGal
• ft³
• ft
• in
Imperial units
impGal
Custom-specific units
Free text
Factory setting %
Additional information The selected unit is only used to be indicated on the display. The measured value is not
transformed according to the selected unit.
It is also possible to configure a distance-to-distance linearization, i.e. a
transformation from the level unit to a different distance unit. To do so, select the
Linear linearization mode. In order to define the new level unit, select the Free text
option in the Unit after linearization parameter and enter the required unit into the
Free text parameter (→  153).
Free text 
Navigation  Setup → Advanced setup → Linearization → Free text
Prerequisite Unit after linearization (→  152) = Free text
Description Enter unit symbol.
User entry Up to 32 alphanumerical characters (letters, numbers, special characters)
Factory setting Free text
Level linearized
Navigation  Setup → Advanced setup → Linearization → Level linearized
Description Displays linearized level.
Additional information • The unit is defined by the Unit after linearization parameter →  152.
• For interface measurements, this parameter always refers to the total level.