Endress+Hauser Levelflex FMP55 - Intermediate Height

Levelflex FMP55 HART Operating menu
Endress+Hauser 155
Intermediate height 
Navigation  Setup → Advanced setup → Linearization → Intermediate height
Prerequisite Linearization type (→  151) has one of the following values:
• Pyramid bottom
• Conical bottom
• Angled bottom
Description Height of the pyramid, conical or angled bottom.
User entry 0 to 200 m
Factory setting 0 m
Additional information
0%
H
A0013264
H Intermediate height
The unit is defined in the Distance unit parameter (→  128).
Table mode 
Navigation  Setup → Advanced setup → Linearization → Table mode
Prerequisite Linearization type (→  151) = Table
Description Select editing mode of the linearization table.
Selection • Manual
• Semiautomatic
• Clear table
• Sort table
Factory setting Manual