Endress+Hauser Levelflex FMP55 - Assign Measurement Variable; Current Output 1 to 2 Simulation; Process Variable Value

Operating menu Levelflex FMP55 HART
204 Endress+Hauser
Description of parameters
Navigation  Expert → Diagnostics → Simulation
Assign measurement variable 
Navigation  Expert → Diagnostics → Simulation → Assign measurement variable
Selection • Off
• Level
• Interface
*
• Thickness upper layer
*
• Level linearized
• Interface linearized
• Thickness linearized
Factory setting Off
Additional information • The value of the variable to be simulated is defined in the Process variable value
parameter (→  204).
• If Assign measurement variable ≠ Off, a simulation is active. This is indicated by a
diagnotic message of the Function check (C) category.
Process variable value 
Navigation  Expert → Diagnostics → Simulation → Process variable value
Prerequisite Assign measurement variable (→  204) ≠ Off
User entry Signed floating-point number
Factory setting 0
Additional information Downstream measured value processing and the signal output use this simulation value. In
this way, users can verify whether the measuring device has been configured correctly.
Current output 1 to 2 simulation 
Navigation  Expert → Diagnostics → Simulation → Current output 1 to 2 simulation
Description Switch the simulation of the current output on and off.
Selection • Off
• On
* Visibility depends on order options or device settings