Endress+Hauser Levelflex FMP55 - Page 166

Operating menu Levelflex FMP55 HART
166 Endress+Hauser
"Probe length correction" wizard
The Probe length correction wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the probe
length correction are located directly in the Probe settings submenu (→  164).
Navigation  Setup → Advanced setup → Probe settings → Probe length
correction
Confirm probe length 
Navigation  Setup → Advanced setup → Probe settings → Probe length correction → Confirm
probe length
Description →  165
Present probe length 
Navigation  Setup → Advanced setup → Probe settings → Probe length correction → Present
probe length
Description →  164