Endress+Hauser Proline Promass 83 - Group SYSTEM

7 Block OUTPUTS Device Functions Proline Promass 83 MODBUS RS485
84 Endress+Hauser
FAILSAFE MODE
MODBUS register:
Data type:
Access:
4227
3230
Integer
read/write
! Note!
Function is not available unless the PULSE setting was selected in the
OPERATION MODE function (4200).
For safety reasons it is advisable to ensure that the pulse output assumes a
predefined state in the event of a fault. The setting you select here affects only the
pulse output. It has no effect on other outputs and the display (e.g. totalizers).
Options:
0 = FALLBACK VALUE
Output is 0 pulse.
3 = ACTUAL VALUE
Measured value output is based on the current flow measurement. The fault is
ignored.
Factory setting: FALLBACK VALUE
Function description
OUTPUTS → PULSE/FREQUENCY OUTPUT 1 → CONFIGURATION (PULSE)