Endress+Hauser Proline Prosonic Flow 93 - Installation;Removal of Sensor W Insertion

PROline Prosonic Flow 93 FOUNDATION Fieldbus 3 Transducer Blocks (transmission blocks)
Endress+Hauser 139
Add. Line
Multiplex -
Assign
AUTO - OOS Use this parameter to define the second reading to be displayed in
the additional line alternately (every 10 seconds) with the value
defined in the "User Interface Add. Line - Assign" parameter.
Options:
OFF
VOLUME FLOW CH1
VOLUME FLOW CH2
CALC. VOLUME FLOW
VOLUME FLOW % CH1
VOLUME FLOW % CH2
CALC. VOLUME FLOW %
SOUND VELOCITY CH1
SOUND VELOCITY CH2
SOUND VELOCITY AVG.
SIGNAL STRENGTH CH1
SIGNAL STRENGTH CH2
FLOW VELOCITY CH1
FLOW VELOCITY CH2
FLOW VELOCITY AVG.
VOLUME FLOW BARGRAPH % CH1
VOLUME FLOW BARGRAPH % CH2
CALC. VOLUME FLOW BARGRAPH %
SIGNAL BARGRAPH CH1
SIGNAL BARGRAPH CH2
TOTALIZER 1
TOTALIZER 2
TOTALIZER 3
FLOW DIRECTION CH1
FLOW DIRECTION CH2
CALC. FLOW DIRECTION
AI 1 - OUT VALUE
AI 2 - OUT VALUE
AI 3 - OUT VALUE
AI 4 - OUT VALUE
AI 5 - OUT VALUE
AI 6 - OUT VALUE
AI 7 - OUT VALUE
AI 8 - OUT VALUE
PID - IN VALUE (controlled variable)
PID - CAS IN VALUE (remote setpoint value)
PID - OUT VALUE (manipulated variable)
DEVICE PD-TAG (tag name)
Factory setting:
OFF
 Note!
Multiplex mode is suspended as soon as a fault/notice message is
generated. The appropriate error message appears on the display:
• Fault message (identified by a lightning icon):
Multiplex mode is resumed as soon as the fault is no longer active.
• Notice message (identified by an exclamation mark):
Multiplex mode is resumed as soon as the notice message is no
longer active.
“TRANSDUCER_DISP” (E+H parameters) / base index 1500
Parameter Write access
with operating
mode
(MODE_BLK)
Description