Endress+Hauser Proline Prosonic Flow 93 - Overview of Transducer Blocks with E+H Parameters; E+H Parameters of the Transducer Blocks: TRANSDUCER_CH1 (Flow Channel 1) and TRANSDUCER_CH2 (Flow Channel 2)

PROline Prosonic Flow 93 FOUNDATION Fieldbus 3 Transducer Blocks (transmission blocks)
Endress+Hauser 109
3.9 Overview of Transducer Blocks with E+H
parameters
3.10 E+H parameters of the Transducer Blocks:
“TRANSDUCER_CH1” (flow channel 1) and
“TRANSDUCER_CH2” (flow channel 2)
The following table lists all the E+H-specific parameters of the Transducer Blocks
“TRANSDUCER_CH1” (flow channel 1) and “TRANSDUCER_CH2” (flow channel 2). The
conditions which have to be met before changing these parameters are provided on
Page 105.
Here you can find all the E+H-specific parameters of the Transducer Blocks:
• TRANSDUCER_CH1 (flow channel 1) → Page 109
• TRANSDUCER_CH2 (flow channel 2) → Page 109
• TRANSDUCER_DISP (display) → Page 129
• TRANSDUCER_TOT (totalizer) → Page 148
• TRANSDUCER_DIAG (diagnosis) → Page 156
• TRANSDUCER_SERV for servicing purposes only - is not explained here.
“TRANSDUCER_CH1” and “TRANSDUCER_CH2” (E+H parameters) /
Base index 1200 and 1300
Parameter Write access
with operating
mode
(MODE_BLK)
Description
 Note!
A description of the FOUNDATION Fieldbus parameters of this block is provided on Page 106.
Un-/Locking -
Access Code
AUTO - OOS All data of the measuring system are protected against inadvertent
change. Only when the code has been entered in this parameter
can the manufacturer-specific parameters (E+H parameters) be
programmed and the device configuration modified.
You can enable programming by entering:
• Code 93 (factory setting)
• Personal code (see Page 129)
User input:
Max. 4-digit number (0...9999)
 Note!
• If write protection is enabled, access to the manufacturer-
specific parameters is blocked even if the right code is entered.
(More detailed information on write protection is provided in the
Operating Instructions for PROline Prosonic Flow 93
FOUNDATION Fieldbus, BA078D/06/en, Section 5.4).
• You can disable programming again by entering any number
(other than the access code) in this parameter.
• The E+H service organisation can be of assistance if you mislay
your personal code.
• The entry made here does not affect the local display. Therefore
programming via the function matrix must be enabled separately.
Un-/Locking -
Access Status
read only Displays the current status of access to the manufacturer-specific
parameters of the device.
Display:
• LOCKED (parameters cannot be modified)
• ACCESS CUSTOMER (parameters can be modified)