PROline Prosonic Flow 93 FOUNDATION Fieldbus 7 Block BASIC FUNCTION
Endress+Hauser 65
SENSOR
CONFIGURATION
(6882)
Note!
This function is not available unless one of the following options was selected
in the MEASUREMENT function (6880):
• CLAMP ON
• SOUND VELOCITY LIQUID
• INSERTION
Use this function to select the configuration for the ultrasonic sensors, e.g. the
number of traverses (in the Clamp On version) or whether single-path or dual-
path configuration is present (in the Insertion version). The options in this
function depend on the measurement method selected in the MEASUREMENT
function (6880, see Page 63).
Options:
(if “CLAMP ON” was selected in the MEASUREMENT function)
NO. TRAVERSE: 1
NO. TRAVERSE: 2
NO. TRAVERSE: 3
NO. TRAVERSE: 4
Options:
(if “SOUND VELOCITY LIQUID” was selected in the MEASUREMENT function)
NO. TRAVERSE: 1
NO. TRAVERSE: 3
Options:
(if “INSERTION” was selected in the MEASUREMENT function)
SINGLE PATH
DUAL PATH
Factory setting:
NO. TRAVERSE: 2
CABLE LENGTH
(6883)
Use this function to select the length of the sensor cable.
Options:
LENGTH 5m/15 feet
LENGTH 10m/30 feet
LENGTH 15m/45 feet
LENGTH 30m/90 feet
Factory setting:
LENGTH 5m/15 feet
SENSOR
POSITION
(6884)
Note!
This function is not available unless “CLAMP ON” is set in the MEASUREMENT
function (6880, see Page 63), and the number of traverses selected in the
SENSOR CONFIGURATION function (6882) is 2 or 4.
Use this function to view the position of both sensors on the rail.
Display:
5-digit number combination
Function description
BASIC FUNCTION → SENSOR DATA (CH1...CH2) → SENSOR PARAMETER
To Next Page
Loading...
