Endress+Hauser Proline Prosonic Flow 93 Function Manual

PROline Prosonic Flow 93 FOUNDATION Fieldbus 2 Resource Block
Endress+Hauser 91
2.5 Resource Block parameters
The following table lists both the FOUNDATION Fieldbus parameters and the
Endress+Hauser-specific parameters, (from Page 99), of the Resource Block:
Resource Block / base index 258
Parameter Write access with
operating mode
(MODE_BLK)
Description
FOUNDATION Fieldbus parameters
ACK_OPTION AUTO - OOS This parameter is used to specify whether a process alarm must be
acknowledged at the time of alarm detection by the fieldbus host
system. If this option is enabled the process alarm is
acknowledged automatically.
Options:
DISC ALM
Write protection no longer exists and thus the data can be
accessed.
BLOCK ALM
Block alarm
Factory setting:
The option is not enabled for any alarm, the alarms must be
acknowledged.
ALARM_SUM AUTO - OOS Displays the current status of the process alarms in the Resource
Block.
Display:
DISC ALM
Write protection no longer exists and thus the data can be
accessed.
BLOCK ALM
Block alarm
 Note!
In addition, the process alarms can also be disabled in this
parameter group.
ALERT_KEY AUTO - OOS Entry of the identification number of the plant unit.
This information can be used by the fieldbus host system for sorting
alarms and events.
User input:
1...255
Factory setting:
0
BLOCK_ALM AUTO - OOS Displays the current block status with information on pending
configuration, hardware or system errors, including details of the
alarm time (date, time) when the error occurred.
The block alarm is triggered in the event of the following block
errors:
• SIMULATION ACTIVE
• OUT OF SERVICE
 Note!
If the option of the alarm has not been enabled in the
ACK_OPTION parameter, the alarm can only be acknowledged via
this parameter.

Endress+Hauser Proline Prosonic Flow 93 Specifications

General

Brand	Endress+Hauser
Model	Proline Prosonic Flow 93
Category	Measuring Instruments
Language	English