Endress+Hauser Proline Prosonic Flow 93 Function Manual

3 Transducer Blocks (transmission blocks) PROline Prosonic Flow 93 FOUNDATION Fieldbus
156 Endress+Hauser
3.13 E+H parameters: Transducer Block
“TRANSDUCER_DIAG” (diagnosis)
The following table lists all the E+H-specific parameters of the Transducer Block
“TRANSDUCER_DIAG” (diagnosis). The conditions which have to be met before
changing these parameters are provided on Page 105.
“TRANSDUCER_DIAG” (E+H parameters) / base index 1600
Parameter Write access
with operating
mode
(MODE_BLK)
Description
 Note!
A description of the FOUNDATION Fieldbus parameters of this block is provided on Page 106.
Diagnosis -
Actual System
Condition
read only Displays the current system status.
 Note!
A precise error description as well as notes on fault elimination can
be found in the Operating Instructions for PROline Prosonic Flow
93 FOUNDATION Fieldbus, BA078D/06/en, Section 9.
Diagnosis -
Previous
System
Condition
read only Displays the last error messages that occurred.
Un-/Locking -
Access Code
AUTO - OOS All data of the measuring system are protected against inadvertent
change. Only when the code has been entered in this parameter
can the manufacturer-specific parameters (E+H parameters) be
programmed and the device configuration modified.
You can enable programming by entering:
• Code 93 (factory setting)
• Personal code (see Page 129)
User input:
Max. 4-digit number (0...9999)
 Note!
• If write protection is enabled, access to the manufacturer-
specific parameters is blocked even if the right code is entered.
(More detailed information on write protection is provided in the
Operating Instructions for PROline Prosonic Flow 93
FOUNDATION Fieldbus, BA078D/06/en, Section 5.4).
• You can disable programming again by entering any number
(other than the access code) in this parameter.
• The E+H service organisation can be of assistance if you mislay
your personal code.
• The entry made here does not affect the local display. Therefore
programming via the function matrix must be enabled
separately.
Un-/Locking -
Access Status
read only Displays the current status of access to the manufacturer-specific
parameters of the device.
Display:
• LOCKED (parameters cannot be modified)
• ACCESS CUSTOMER (parameters can be modified)

Endress+Hauser Proline Prosonic Flow 93 Specifications

General

Brand	Endress+Hauser
Model	Proline Prosonic Flow 93
Category	Measuring Instruments
Language	English