3 Transducer Blocks (transmission blocks) PROline Prosonic Flow 93 FOUNDATION Fieldbus
108 Endress+Hauser
BLOCK_ALM AUTO - OOS Displays the current block status with information on pending
configuration, hardware or system errors, including details of the
alarm time (date, time) when the error occurred.
Note!
• In addition, the active block alarm can be acknowledged in this
parameter group.
• PROline Prosonic Flow 93 FF does not use this parameter to
display a process alarm since these are generated in the
BLOCK_ALM parameter of the Analog Input function block,
(see Page 169).
Transducer Type read only Displays the Transducer Block type.
Display:
Standard flow with calibration
Transducer Error read only Displays the active device error.
Note!
This parameter is available in all Transducer Blocks.
However, the device errors (apart from “No Error”) are only
displayed via the BLOCK_ERR parameter of the Transducer Block
TRANSDUCER_DIAG (diagnosis, base index 1600).
Possible display:
• No Error (normal state)
• Electronis Failure
• Data Integrity Error
• Mechanical Error
• Configuration Error
• General Error
Note!
• Display of the device error is standardised. Precise information
on the pending error is available via the manufacturer-specific
error display which can be read in the “Diagnosis - Actual
System Condition” parameter in the Transducer Block
TRANSDUCER_DIAG (diagnosis, base index 1600).
• A precise error description as well as notes on fault elimination
can be found in the Operating Instructions for PROline Prosonic
Flow 93 FF, BA 078D/06/en.
FOUNDATION Fieldbus parameters (Transducer Blocks, transmission blocks)
Parameter Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
