Endress+Hauser SpectraSensors J22 TDLAS - Carrying out a Sensor Adjustment

4900002277 J22 TDLAS Gas Analyzer
70 SpectraSensors, Inc.
Parameter overview with brief description
Carrying out a sensor adjustment
The sensor adjustment submenu contains parameters that pertain to the
functionality of the sensor.
Navigation
"Setup" menu → Advanced setup → Sensor adjustment
Parameter overview with brief description
Parameter Description User Entry Factory Setting
Analyte type The analyte measured by the analy-
zer.
— H
2
O
Cal select Changes and sets the calibration •1
•2
•3
•4
1
Rolling avg num Sets the number of measurements
included in the running average.
Positive integer 4
Sensor adjustment
Conc. adjust
Conc. multiplier
Base crv source
Base RT update
Calibration 1 to n
→  71
Conc. offset
Parameter Prerequisite Description Selection Factory Setting
Conc. adjust — Enables or disables
adjustment factors.
•On
•Off
Off
Conc. multiplier Used if Concentra-
tion Adjust is
enabled.
Slope adjustment fac-
tor.
Signed floating
point number
1.0