218 Installing Options
To confirm that the memory module is installed correctly, print a
status sheet. See “Printing a Status Sheet” on page 276 for
instructions. If the total amount of memory listed does not include
the size of the optional memory module, try reinstalling the
module. Make sure that the module is securely seated into the
memory slot on the circuit board.
Note for Windows users:
If you are using Windows, and EPSON Status Monitor 3 is not
installed, you have to make settings manually in the printer driver. See
“Making Optional Settings” on page 83.
Note for Macintosh users:
When you have attached or removed printer options, you need to delete
the printer using Print Setup Utility (for Mac OS X 10.3), Print
Center (for Mac OS X 10.2 or below), or Chooser (for Mac OS 9),
and then re-register the printer.
Removing a memory module
Follow the steps below to remove a memory module.
c
Caution:
Before you remove a memory module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Be careful when working inside the printer as some components
are sharp and may cause injury.
1. Turn the printer off and unplug the power cord.
2. Perform the installation procedure in reverse.
To Next Page
Loading...
