50 Paper Handling
Labels
You can load up to 18 mm thickness of labels into the MP tray at
a time. However, you may need to feed some labels one sheet at
a time, or load them manually.
Note:
❏ Duplex printing is not available for labels.
❏ Depending on the quality of labels, the printing environment, or the
printing procedure, labels might be wrinkled. Make a trial print run
before you print on a lot of labels.
When loading labels, you should make paper settings as shown
below:
❏ Make settings on the Basic Settings in the printer driver.
❏ You can also make these settings on the Tray Menu in the
control panel. See “Tray Menu” on page 346.
Note:
❏ You should only use labels designed for monochrome laser printers
or monochrome plain-paper copiers.
❏ To prevent the label adhesive from coming into contact with printer
parts, always use labels that completely cover the backing sheet, with
no gaps between the individual labels.
❏ Press a sheet of paper on top of each sheet of labels. If the paper sticks,
do not use those labels in your printer.
❏ You may have to make the setting Thick* for Paper Type in the
Setup Menu.
*When using especially thick labels, set Paper Type to ExtraThk.
Paper Size Paper Source Paper Type
A4 or LT MP Tray (up to 18 mm
thick stack)
Labels
To Next Page
Loading...
Need help?
General
