48 Paper Handling
❏ When printing on the back side of previously printed paper,
select Coated (Back) or Coated Glossy (Back).
❏ When printing with the Duplex Unit, you cannot select
Coated Glossy for the Paper Type.
❏ You can also make these settings on the Tray Menu in the
control panel. See “Tray Menu” on page 346.
Envelopes
The print quality of envelopes may be irregular because different
parts of an envelope have different thicknesses. Print one or two
envelopes to check the print quality.
Note:
❏ Depending on the quality of envelopes, the printing environment,
or the printing procedure, envelopes might be wrinkled. Make a trial
print run before you print on a lot of envelopes.
❏ Duplex printing is not available for envelopes.
When loading envelopes, you should make paper settings as
shown below:
❏ Make settings on the Basic Settings in the printer driver.
❏ You can also make these settings on the Tray Menu in the
control panel. See “Tray Menu” on page 346.
Please note the following when handling this media.
❏ Do not use an envelope that has glue or tape on it.
Paper Size Paper Source
Mon, C10, DL, C6, or
ISO-B5
MP Tray (up to 18 mm thick stack)
To Next Page
Loading...
