Epson Aculaser c9100 - Status and Error Messages

Troubleshooting 299
8
8
8
8
8
8
8
8
8
8
8
8
Status and Error Messages
This section contains a list of error messages shown on the LCD
panel, giving a brief description of each message and suggestions
for correcting the problem. Note that not every message shown
on the LCD panel indicates a problem. When the mark is
displayed at the left of the warning message, multiple warnings
occur. To confirm all warnings that occur, press the Down
button to display the Status Menu, then press the Enter
button.
Calibrating Printer
The printer automatically calibrates itself when any of its covers
are closed and when there is no paper jammed inside. This is not
an error message, and will clear itself within one minute. While
the printer displays this message, do not open the covers or turn
off the printer.
Cancel All Print Job
The printer is canceling all print jobs in the printer memory,
including jobs the printer is currently receiving or printing. This
message appears when the + Cancel Job button has been pressed
down for more than 2 seconds.
Cancel Print Job
The printer is canceling the current print job. This message
appears when the + Cancel Job button has been pressed and
released within 2 seconds.
Can’t Print
The print data is deleted because it is incorrect.
Make sure that the appropriate paper size is set and appropriate
your printer driver is used.