Functions of the Control Panel 373
B
B
B
B
B
B
B
B
B
B
B
B
Auto CR
Specifies whether the printer performs a
carriage-return/line-feed (CR-LF) operation whenever the
printing position goes beyond the right margin. If you select Off,
the printer does not print any characters beyond the right margin
and does not perform any line wrapping until it receives a
carriage-return character. This function is handled automatically
by most applications.
Auto LF
If you select Off, the printer does not send an automatic line-feed
(LF) command with each carriage-return (CR). If On is selected, a
line-feed command is sent with each carriage-return. Select On if
your text lines overlap.
Bit Image
The printer is able to emulate the graphics densities set with the
printer commands. If you select Dark, the bit image density is
high, and if you select Light, the bit image density is low.
If you select BarCode, the printer converts bit images to bar codes
by automatically filling in any vertical gaps between dots. This
produces unbroken vertical lines that can be read by a bar code
reader. This mode will reduce the size of the image being printed,
and may also cause some distortion when printing bit image
graphics.
ZeroChar
Selects whether the printer prints a slashed or unslashed zero.
To Next Page
Loading...
