Using Multiple Projectors
150
Setting the Projector ID
To control multiple projectors from a remote control, give each projector a
unique ID.
a
Press the [Menu] button and do the following:
• EB‑‑755F/EB‑‑750F: select the Multi-Projection menu and press
[Enter].
• EB‑‑735Fi/EB‑‑735F/EB‑‑725Wi/EB‑‑725W/EB‑‑720: select the
Installation menu and press [Enter].
b
Select Projector ID and press [Enter].
c
Use the arrow buttons to select the identification number you want to
use for the projector. Then press [Enter].
d
Press [Menu] or [Esc] to exit the menus.
e
Repeat these steps for all the other projectors you want to operate from
one remote control.
Selecting the Projector You want to Operate
After setting the projector's ID, select the ID for the projector you want to
operate using the remote control.
a
Aim the remote control at the target projector and press the [ID]
button.
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
To Next Page
Loading...
Need help?
General
