Projector Connections
33
b
Connect the other end to a Computer port on the projector.
c
Tighten the screws on the VGA connector.
d
Connect the audio cable to your laptop's headphone or audio-out jack,
or your desktop's speaker or audio-out port.
e
Connect the other end to the Audio port that corresponds to the
Computer port you are using.
Connecting to a Computer for USB Video and Audio
If your computer meets the system requirements, you can send video and
audio output to the projector through the computer's USB port. This function
is called USB Display. Connect the projector to your computer using a USB
cable.
a
• If you use a USB hub, the connection may not operate correctly.
Connect the USB cable directly to the projector.
• To use the USB Display function, set the USB Display setting to On
in the projector's Signal I/O menu (EB‑735Fi/EB‑725Wi).
a
Connect the cable to your projector's USB-B1 or USB-B port.
b
Connect the other end to any available USB port on your computer.
c
Turn on the projector and your computer.
d
Do one of the following to install the Epson USB Display software:
To Next Page
Loading...
Need help?
General
