Using Multiple Projectors
151
b
While holding the [ID] button, press the number button that matches
the ID of the projector you want to operate.
The projector you want to operate is selected.
a
• When you select [0/All] on the remote control, you can
operate all projectors regardless the Projector ID setting.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• The projector ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and
so on, the saved ID setting is retained. However, if the batteries
are left out of the remote control for an extended period, the
ID returns to its default setting (0/All).
• When you use multiple remote controls at the same time, you
may not be able to operate projectors as intended due to
infrared interference.
Adjusting Color Uniformity
If the color tone of the image is uneven, you can adjust the color tone balance.
Adjust the Color Uniformity setting for each projector.
a
The color tone may not be uniform even after adjusting the color
uniformity.
a
Press the [Menu] button, select the Management menu, and press
[Enter].
To Next Page
Loading...
Need help?
General
