Projector Interactive Settings - Interactive Menu
240
Interactive Menu - Mail Menu
Settings on the Mail menu let you select the email settings.
Setting Options Description
Mail Function On
Off
Set to On to enable sending of emails
containing captured whiteboard
drawings.
SMTP Server Up to 64
alphanumeric
characters
(do not use " * + , : ;
< = > ? [ \ ] ` | and
spaces)
Enter the IP address or FQDN (Fully
Qualified Domain Name) for the SMTP
server. You cannot use the following IP
addresses: 127.x.x.x, 192.0.2.x, or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). If
you specify an FQDN, you must
configure a DNS server.
Authentication Open
Auth
SSL
TLS
Sets the type of authentication expected
by the SMTP server.
Port Number 1 to 65535 The default port varies depending on the
Authentication setting: 25 for Open, 465
for SSL, and 587 for TLS.
User name Up to 64
alphanumeric
characters
(do not use : and
spaces)
Enter a user name for the SMTP server.
Password Up to 64
alphanumeric
characters
(do not use : and
spaces)
Enter a password for the SMTP server.
Setting Options Description
From Up to 64
alphanumeric
characters
(do not use " ( ) , : ;
< > [ \ ] and spaces)
Enter the email address to be displayed
to the sender.
Default e-mail
address
Up to 64
alphanumeric
characters
(do not use " ( ) , : ;
< > [ \ ] and spaces)
Enter the default email address used to
send emails. You can also specify the
domain name following an at mark to aid
email address input; for example,
"@xxx.co.jp".
Send a test e-mail — Connects to the SMTP server and sends a
test email to the address you set as the
default.
Disallow Address
Input
On
Off
Set to On to choose e-mail addresses
only from an address book or directory
service.
Interactive Menu - Directory Menu
Settings on the Directory menu let you select the directory service settings.
Setting Options Description
Directory Access
Function
On
Off
Set to On to search for user names and
email addresses from a directory service.
LDAP Server Up to 64
alphanumeric
characters
(do not use " * + , : ;
< = > ? [ \ ] ` | and
spaces)
Enter the IP address or FQDN (Fully
Qualified Domain Name) for the LDAP
server. You cannot use the following IP
addresses: 127.x.x.x, 192.9.2.x, or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). If
you specify an FQDN, you must
configure a DNS server.
Port Number 1 to 65535 Enter a port number for the LDAP
server. The default port is 389. Specify
"3268" to search the global catalog.
To Next Page
Loading...
Need help?
General
