Installing Batteries in the Remote Control
44
The remote control uses the two AA batteries that came with the projector.
Attention
Make sure you read the Safety Instructions before handling the batteries.
a
Replace the batteries as soon as they run out. The remote control uses
two AA manganese or alkaline batteries.
a
Remove the battery cover as shown.
b
Remove the old batteries, if necessary.
a
Dispose of used batteries according to local regulations.
c
Insert the batteries with the + and – ends facing as shown.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
correctly, they could explode or leak causing a fire, injury, or damage to the
product.
d
Replace the battery cover and press it down until it clicks into place.
To Next Page
Loading...
Need help?
General
