Epson RC180 - Page 199

Maintenance 8. Trouble Shooting
RC180 Rev.17 187
No.
Message
Remedy
Note 1
Note 2
2161
Operation failure.
Failed to allocate the local variable
address.
Reboot the Controller.
2162
Operation failure.
Not enough
buffer to store the local
variable.
Review the size of the Local variable.
2163
Operation failure.
Value change is available only when
the task is halted.
Halt the task by the break point.
2164
Operation failure.
Failed to allocate the global variable
address.
Review the size of the global variable.
2165
Operation failure.
Not enough buffer to store the global
variable.
Review the size of the global variable.
2166
Operation failure.
Failed to obtain the Global Preserve
variable address.
Review the size of the global preserve
variable.
2167
Operation failure.
Not enough buffer to store the Global
Preserve variable.
Review the size of the global preserve
variable.
2168
Operation failure.
SRAM is not mapped.
Reboot the Controller.
2169
Operation failure.
Cannot clear the Global Preserve
variable when loading the object file.
Reboot the Controller.
2170
Operation failure.
Not enough buffer to store the string.
Check the size of the string variable.
2171
Operation failure.
Cannot start the task after low voltage
was detected.
Check the controller power.
Reboot the Controller.
2172
Operation failure.
Duplicated remote I/O configuration.
Reboot the Controller.
2173
Remote setup error.
Cannot assign non-
existing input
number to remote function.
Check the I/O input number.
2174
Remote setup error.
Cannot assign non-
existing output
number to remote function.
Check the I/O output number.
2175
Operation failure.
Remote function is not configured.
Reboot the Controller.
2176
Operation failure.
Event wait error.
Reboot the Controller.
2177
Operation failure.
System backup failed.
Reboot the Controller.
Install the Controller firmware.
2178
Operation failure.
System restore failed.
Reboot the Controller.
Install the Controller firmware.
2179
Remote setup error.
Cannot assign same input number to
some remote functions.
Check the remote setting.
2180
Remote setup error.
Cannot assign same output number to
some remote functions.
Check the remote setting.
2190
Cannot calculate because it was queue
data.
Review the program.