Epson Stylus Pro GS6000 - Boards

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 109
Confidential
4.4.6 Boards
4.4.6.1 LVDS BOARD ASSY
1. Remove the five screws and open the Elec Box.
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
Figure 4-57. Opening the Elec Box
2. Disconnect the serial cable and the FFC.
3. Remove the two screws and remove the board.
A) Silver, Phillips, Cup M3x6: two pieces
Figure 4-58. Removing the LVDS BOARD ASSY
Connector assignment:
Elec Box
A
Elec Box
As seen from the rear bottom
Connector No. Color Destination
J1
(FFC) MAIN BOARD ASSY (CN507)
J2
Gray HEATER CONT BOARD ASSY (J10)
LVDS BOARD ASSY
A
Inside the Box
FFC
Serial cable