Epson Stylus Pro GS6000 - Ink System Mechanism

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 158
Confidential
4.4.11 Ink System Mechanism
4.4.11.1 PRINT HEAD/VALVE ASSEMBLY, HEAD
1. Unlock the Carriage. (p83)
2. Remove the TOP COVER (left only). (p85)
3. Remove the MAINTE COVER T. (p88)
4. Remove the CR Cover (Step 4 to 6 in 4.4.5.3 COOLING FAN). (p104)
5. Remove the four screws and remove the Left Front Plate (not an ASP).
A) Silver, Phillips, Pan with S.W & P.W M4x8: four screws
Figure 4-129. Removing the Left Front Plate
6. Move the Carriage back to the left end.
7. Remove the two screws and remove the two grounding wires.
Figure 4-130. Removing the grounding wires
C H E C K
P O I N T
There are two heads, but basically you can remove both heads in
the same way. Therefore this section describes the way to remove
one of the heads only.
C A U T I O N
 When replacing the PRINT HEAD, make sure to replace the
VALVE ASSEMBLY, HEAD together.
 It is also recommended to replace the HEAD WIPER and the
HEAD CAPS if they are not in good condition (Dried ink).
A
Left Front Plate
As seen from the front
Screws
Grounding wires