Epson Stylus Pro GS6000 Revision F
MAINTENANCE Setting up and Transportation 243
Confidential
6.2.2 Transportation
When detaching the body section of the printer from the Stand, follow the steps below.
1. Insert the two carrying bars into their carrier holes (two each) at the bottom of the printer.
2. Verify that the bars are inserted until the heads of the screws touch the carrier
holes, then turn the bars so that there is a screw head in both sides of the carrier
hole's sides. (This prevents the bars from sliding during the transport.).
Figure 6-2. Preparation to Carry the Body Section
3. Lift the body section using the carrying bars by six people to remove it from Stand.
Figure 6-3. Detaching the Body Section
For the transport, if 950ml cartridges were used, they should be
removed from the printer and transported “flat”, wider side down
as vibrations could make the weight of the ink moving inside the
pocket causing premature wear of the pocket lower side when the
cartridge is transported on its narrow side (insertion position). If
this cannot be guaranteed, the 950ml used cartridges should not be
transported and discarded instead, as a precaution. (New
cartridges, cleaning cartridges and initial charge ink cartridges can
be transported in any direction.)
To Next Page
Loading...
